JET KIT

Jetworks Jet Kit

The Jetworks jet kit offers the proper jetting for the use of aftermarket spark arrestors and will also work well along with other pipe modifications like our 155SPK. This jet kit will also work well with aftermarket OEM pipe tubes or pipe kits that utilize a whole new rear tube section.

The jet kit consists of 3 needle and seats, 3 springs, 3 low speed jets, 3 main jets and 2 restrictors for the accelerator pump circuit. This jetting kit allows lower pop off pressures to help eliminate midrange - upper range lean out condition. The 2 restrictors for the accelerator pump circuit allow you to run larger low speed jets than normal, further reducing the lean out condition. The kit comes with instructions on how to adjust the accelerator pump volume, float arm height, and screw adjuster settings.

This system is fully tested and precise. The jet kit will allow accelerator pump operation upon sudden throttle opening but it will not continue to spray fuel if you repeatedly work the throttle or re-apply the throttle after quickly letting off the throttle. This allows much better response in tight turns

NOTE: The kit is sold as a kit only and our technicians are not allowed to discuss the specifics of the items in the kit.
This item is not returnable.

Y155JK-2	JET KIT (for models with 2 accelerator pump discharges)	$ 79.95
Y155JK-3	JET KIT (for models with 3 accelerator pump discharges)	$ 79.95

Email